User's Guide
Table Of Contents
- RUGGEDCOM SAS-GW
- Table of Contents
- Preface
- 1. Introduction
- 2. Installation and Deployment
- 3. Using RUGGEDCOM SAS-GW
- 4. Configuring RUGGEDCOM SAS-GW
- 4.1. Configuring the Local Time Zone
- 4.2. Configuring the SNMP Read/Write Communities
- 4.3. Managing User Accounts
- 4.4. Managing Base Stations
- 4.4.1. Adding a Base Station
- 4.4.2. Updating a Base Station's Configuration
- 4.4.3. Updating a Base Station's Location
- 4.4.4. Updating a Base Station's Antenna Characteristics
- 4.4.5. Updating SNMP Settings
- 4.4.6. Updating CPI Information
- 4.4.7. Removing a Base Station
- 4.4.8. Viewing Available Base Stations
- 4.4.9. Viewing the Measurements Report
- 4.4.10. Viewing the SAS Registration Information
- 4.5. Managing Subscriber Units
- 5. Monitoring RUGGEDCOM SAS-GW
Chapter 4
Configuring RUGGEDCOM SAS-GW
RUGGEDCOM SAS-GW
User Guide
42 Configuring SMS Alerts
3
2
1
Figure25:Password Tab
1.New Password Box 2.Confirm Password Box 3.Change Password Button
NOTE
Passwords must be between 8 and 50 characters.
4. Under New Password and Confirm Password, enter the new password.
5. Click Change Password.
Section4.3.4
Configuring SMS Alerts
Individual user profiles can be configured to receive Short Message Service (SMS) alerts from RUGGEDCOM SAS-
GW when specific events occur during operation. All alerts are sent via text message to the user's phone number.
By default, SMS alerts are disabled for each new user profile.
To configure SMS alerts for a specific user profile, do the following:
IMPORTANT!
SMS alerts must be enabled before they are configured. For more information, refer to Section2.4,
“Enabling SMS Alerts” .
1. Point to Users and then click either My Account to edit the current profile, or open the View All Users list
and click Edit next to the desired user profile.
For more information about accessing the View All Users list, refer to Section4.3.6, “Listing User Accounts” .
The My Account or Update Account screen appears.