User's Guide
Table Of Contents
- RUGGEDCOM SAS-GW
- Table of Contents
- Preface
- 1. Introduction
- 2. Installation and Deployment
- 3. Using RUGGEDCOM SAS-GW
- 4. Configuring RUGGEDCOM SAS-GW
- 4.1. Configuring the Local Time Zone
- 4.2. Configuring the SNMP Read/Write Communities
- 4.3. Managing User Accounts
- 4.4. Managing Base Stations
- 4.4.1. Adding a Base Station
- 4.4.2. Updating a Base Station's Configuration
- 4.4.3. Updating a Base Station's Location
- 4.4.4. Updating a Base Station's Antenna Characteristics
- 4.4.5. Updating SNMP Settings
- 4.4.6. Updating CPI Information
- 4.4.7. Removing a Base Station
- 4.4.8. Viewing Available Base Stations
- 4.4.9. Viewing the Measurements Report
- 4.4.10. Viewing the SAS Registration Information
- 4.5. Managing Subscriber Units
- 5. Monitoring RUGGEDCOM SAS-GW
Chapter 4
Configuring RUGGEDCOM SAS-GW
RUGGEDCOM SAS-GW
User Guide
46 Listing User Accounts
4. Click Yes.
Section4.3.6
Listing User Accounts
To view a list of user accounts configured for RUGGEDCOM SAS-GW, point to User and then click All Users. The
View All Users screen appears.
Figure30:View All Users Screen
This screen displays the following information about each user:
Column Description
ID A numeric identifier assigned automatically to the user.
User Name The user's user name.
Account State The user's current state. Active indicates the user is currently logged in.
Name The user's first and last name.
E-Mail Address The user's e-mail address.
Last Sign In Time The date and time when the user last logged on.
Section4.4
Managing Base Stations
This section describes how to configure and manage base stations in RUGGEDCOM SAS-GW.
CONTENTS
• Section4.4.1, “Adding a Base Station”
• Section4.4.2, “Updating a Base Station's Configuration”
• Section4.4.3, “Updating a Base Station's Location”
• Section4.4.4, “Updating a Base Station's Antenna Characteristics”