User's Guide
Table Of Contents
- RUGGEDCOM SAS-GW
- Table of Contents
- Preface
- 1. Introduction
- 2. Installation and Deployment
- 3. Using RUGGEDCOM SAS-GW
- 4. Configuring RUGGEDCOM SAS-GW
- 4.1. Configuring the Local Time Zone
- 4.2. Configuring the SNMP Read/Write Communities
- 4.3. Managing User Accounts
- 4.4. Managing Base Stations
- 4.4.1. Adding a Base Station
- 4.4.2. Updating a Base Station's Configuration
- 4.4.3. Updating a Base Station's Location
- 4.4.4. Updating a Base Station's Antenna Characteristics
- 4.4.5. Updating SNMP Settings
- 4.4.6. Updating CPI Information
- 4.4.7. Removing a Base Station
- 4.4.8. Viewing Available Base Stations
- 4.4.9. Viewing the Measurements Report
- 4.4.10. Viewing the SAS Registration Information
- 4.5. Managing Subscriber Units
- 5. Monitoring RUGGEDCOM SAS-GW
RUGGEDCOM SAS-GW
User Guide
Chapter 4
Configuring RUGGEDCOM SAS-GW
Adding a Base Station 47
• Section4.4.5, “Updating SNMP Settings”
• Section4.4.6, “Updating CPI Information”
• Section4.4.7, “Removing a Base Station”
• Section4.4.8, “Viewing Available Base Stations”
• Section4.4.9, “Viewing the Measurements Report”
• Section4.4.10, “Viewing the SAS Registration Information”
Section4.4.1
Adding a Base Station
To add a new base station to RUGGEDCOM SAS-GW, do the following:
1. Point to Setup and then click Add BS. The Create New Base Station screen appears.