User's Guide
Table Of Contents
- RUGGEDCOM SAS-GW
- Table of Contents
- Preface
- 1. Introduction
- 2. Installation and Deployment
- 3. Using RUGGEDCOM SAS-GW
- 4. Configuring RUGGEDCOM SAS-GW
- 4.1. Configuring the Local Time Zone
- 4.2. Configuring the SNMP Read/Write Communities
- 4.3. Managing User Accounts
- 4.4. Managing Base Stations
- 4.4.1. Adding a Base Station
- 4.4.2. Updating a Base Station's Configuration
- 4.4.3. Updating a Base Station's Location
- 4.4.4. Updating a Base Station's Antenna Characteristics
- 4.4.5. Updating SNMP Settings
- 4.4.6. Updating CPI Information
- 4.4.7. Removing a Base Station
- 4.4.8. Viewing Available Base Stations
- 4.4.9. Viewing the Measurements Report
- 4.4.10. Viewing the SAS Registration Information
- 4.5. Managing Subscriber Units
- 5. Monitoring RUGGEDCOM SAS-GW
Chapter 4
Configuring RUGGEDCOM SAS-GW
RUGGEDCOM SAS-GW
User Guide
48 Adding a Base Station
14
13
1
12
2
3
4
5
6
8
7
9
10
11
Figure31:Create New Base Station Screen
1.BST Name Box 2.IP Address Box 3.Frequency Start Box 4.Frequency Stop Box 5.Serial Number 6.BST Max Tx Power
Box 7.BST Max EIRP Box 8.SAS Control List 9.Report Measurements to SAS List 10.CBSD Device Category List 11.CBSD
Group List 12.Apply Button 13.Fetch Data Button 14.Fetch Installation Parameters Button
2. Configure the following parameters.
Parameter Description
BST Name Synopsis: A string
A unique name for the base station.
IP Address Synopsis: An IPv4 address
The base station's IP address.