User's Guide
Table Of Contents
- RUGGEDCOM SAS-GW
- Table of Contents
- Preface
- 1. Introduction
- 2. Installation and Deployment
- 3. Using RUGGEDCOM SAS-GW
- 4. Configuring RUGGEDCOM SAS-GW
- 4.1. Configuring the Local Time Zone
- 4.2. Configuring the SNMP Read/Write Communities
- 4.3. Managing User Accounts
- 4.4. Managing Base Stations
- 4.4.1. Adding a Base Station
- 4.4.2. Updating a Base Station's Configuration
- 4.4.3. Updating a Base Station's Location
- 4.4.4. Updating a Base Station's Antenna Characteristics
- 4.4.5. Updating SNMP Settings
- 4.4.6. Updating CPI Information
- 4.4.7. Removing a Base Station
- 4.4.8. Viewing Available Base Stations
- 4.4.9. Viewing the Measurements Report
- 4.4.10. Viewing the SAS Registration Information
- 4.5. Managing Subscriber Units
- 5. Monitoring RUGGEDCOM SAS-GW
RUGGEDCOM SAS-GW
User Guide
Chapter 4
Configuring RUGGEDCOM SAS-GW
Updating a Base Station's Configuration 51
13
14
1
12
2
3
4
5
6
7
8
9
10
11
Figure34:Update Base Station Screen
1.BST Name Box 2.IP Address Box 3.Frequency Start Box 4.Frequency Stop Box 5.Serial Number 6.BST Max Tx Power
Box 7.BST Max EIRP Box 8.SAS Control List 9.Report Measurements to SAS List 10.CBSD Device Category List 11.CBSD
Group List 12.Apply Button 13.Delete Button 14.Deregister from SAS Button
2. On the General tab, update the following parameters as needed:
Parameter Description
BST Name Synopsis: A string
A unique name for the base station.
IP Address Synopsis: An IPv4 address
The base station's IP address.