User's Guide
Table Of Contents
- RUGGEDCOM SAS-GW
- Table of Contents
- Preface
- 1. Introduction
- 2. Installation and Deployment
- 3. Using RUGGEDCOM SAS-GW
- 4. Configuring RUGGEDCOM SAS-GW
- 4.1. Configuring the Local Time Zone
- 4.2. Configuring the SNMP Read/Write Communities
- 4.3. Managing User Accounts
- 4.4. Managing Base Stations
- 4.4.1. Adding a Base Station
- 4.4.2. Updating a Base Station's Configuration
- 4.4.3. Updating a Base Station's Location
- 4.4.4. Updating a Base Station's Antenna Characteristics
- 4.4.5. Updating SNMP Settings
- 4.4.6. Updating CPI Information
- 4.4.7. Removing a Base Station
- 4.4.8. Viewing Available Base Stations
- 4.4.9. Viewing the Measurements Report
- 4.4.10. Viewing the SAS Registration Information
- 4.5. Managing Subscriber Units
- 5. Monitoring RUGGEDCOM SAS-GW
Chapter 4
Configuring RUGGEDCOM SAS-GW
RUGGEDCOM SAS-GW
User Guide
56 Updating a Base Station's Antenna Characteristics
4. Click Apply.
Section4.4.4
Updating a Base Station's Antenna Characteristics
To update the charactistics of the antenna installed on a base station, do the following:
1. Left-click the base station on the map and then click Edit, or open the View All Base Stations list and click
Edit next to the desired base station.
For information about accessing the View All Base Stations list, refer to Section4.4.8, “Viewing Available
Base Stations” .
2
1
Figure38:Editing a Base Station from the Map
Once clicking Edit, the Update Base Station screen appears.