User's Guide
Table Of Contents
- RUGGEDCOM SAS-GW
- Table of Contents
- Preface
- 1. Introduction
- 2. Installation and Deployment
- 3. Using RUGGEDCOM SAS-GW
- 4. Configuring RUGGEDCOM SAS-GW
- 4.1. Configuring the Local Time Zone
- 4.2. Configuring the SNMP Read/Write Communities
- 4.3. Managing User Accounts
- 4.4. Managing Base Stations
- 4.4.1. Adding a Base Station
- 4.4.2. Updating a Base Station's Configuration
- 4.4.3. Updating a Base Station's Location
- 4.4.4. Updating a Base Station's Antenna Characteristics
- 4.4.5. Updating SNMP Settings
- 4.4.6. Updating CPI Information
- 4.4.7. Removing a Base Station
- 4.4.8. Viewing Available Base Stations
- 4.4.9. Viewing the Measurements Report
- 4.4.10. Viewing the SAS Registration Information
- 4.5. Managing Subscriber Units
- 5. Monitoring RUGGEDCOM SAS-GW
RUGGEDCOM SAS-GW
User Guide
Chapter 4
Configuring RUGGEDCOM SAS-GW
Updating SNMP Settings 59
4. [Optional] Configure the following additional parameter:
Parameter Description
Model Synopsis: A string between 1 and 128 characters
The platform name or part number of the antenna (e.g. WIN7237).
5. Click Apply.
Section4.4.5
Updating SNMP Settings
The Simple Network Management Protocol (SNMP) allows SNMP managers to monitor and manage devices on
their IP network. In the case of RUGGEDCOM SAS-GW, SNMP allows base stations and their subscriber units to send
information to RUGGEDCOM SAS-GW about important events related to their status. RUGGEDCOM SAS-GW can
also query devices for specific information and modify their configurations (e.g. enable/disable transmission).
NOTE
For information about traps sent by the base and subscriber units, refer to the base or subscriber unit's
user documentation.
RUGGEDCOM SAS-GW specifically supports SNMPv2c, a variant of SNMPv2 that features community string-based
authentication. Read-only access is granted if the RUGGEDCOM SAS-GW belongs to the SNMP read community.
Full read/write access is granted if RUGGEDCOM SAS-GW belongs to the SNMP write community.
To update the SNMP settings for a specific base station, do the following:
1. Left-click the base station on the map and then click Edit, or open the View All Base Stations list and click
Edit next to the desired base station.
For information about accessing the View All Base Stations list, refer to Section4.4.8, “Viewing Available
Base Stations” .