User's Guide
Table Of Contents
- RUGGEDCOM SAS-GW
- Table of Contents
- Preface
- 1. Introduction
- 2. Installation and Deployment
- 3. Using RUGGEDCOM SAS-GW
- 4. Configuring RUGGEDCOM SAS-GW
- 4.1. Configuring the Local Time Zone
- 4.2. Configuring the SNMP Read/Write Communities
- 4.3. Managing User Accounts
- 4.4. Managing Base Stations
- 4.4.1. Adding a Base Station
- 4.4.2. Updating a Base Station's Configuration
- 4.4.3. Updating a Base Station's Location
- 4.4.4. Updating a Base Station's Antenna Characteristics
- 4.4.5. Updating SNMP Settings
- 4.4.6. Updating CPI Information
- 4.4.7. Removing a Base Station
- 4.4.8. Viewing Available Base Stations
- 4.4.9. Viewing the Measurements Report
- 4.4.10. Viewing the SAS Registration Information
- 4.5. Managing Subscriber Units
- 5. Monitoring RUGGEDCOM SAS-GW
Chapter 4
Configuring RUGGEDCOM SAS-GW
RUGGEDCOM SAS-GW
User Guide
62 Updating SNMP Settings
5
6
1
4
2
3
Figure43:SNMP Tab
1.SNMP Version List 2.V2c Read Community Box 3.V2c Write Community Box 4.Apply Button 5.Delete Button
6.Deregister from SAS Button
3. Update the following parameters as needed:
Parameter Description
SNMP Version Synopsis: { SNMPv2c, SNMPv3-NA }
Default: SNMPv2c
The version of SNMP used by the base station.
V2c Read Community Synopsis: A string
Default: public
The name of the SNMP read community.
The community name must match the name defined in the base station's SNMP
configuration.
V2c Write Community Synopsis: A string
Default: private
The name of the SNMP write community.
The community name must match the name defined in the base station's SNMP
configuration.
4. Click Apply.