User's Guide
Table Of Contents
- RUGGEDCOM SAS-GW
- Table of Contents
- Preface
- 1. Introduction
- 2. Installation and Deployment
- 3. Using RUGGEDCOM SAS-GW
- 4. Configuring RUGGEDCOM SAS-GW
- 4.1. Configuring the Local Time Zone
- 4.2. Configuring the SNMP Read/Write Communities
- 4.3. Managing User Accounts
- 4.4. Managing Base Stations
- 4.4.1. Adding a Base Station
- 4.4.2. Updating a Base Station's Configuration
- 4.4.3. Updating a Base Station's Location
- 4.4.4. Updating a Base Station's Antenna Characteristics
- 4.4.5. Updating SNMP Settings
- 4.4.6. Updating CPI Information
- 4.4.7. Removing a Base Station
- 4.4.8. Viewing Available Base Stations
- 4.4.9. Viewing the Measurements Report
- 4.4.10. Viewing the SAS Registration Information
- 4.5. Managing Subscriber Units
- 5. Monitoring RUGGEDCOM SAS-GW
Chapter 4
Configuring RUGGEDCOM SAS-GW
RUGGEDCOM SAS-GW
User Guide
66 Removing a Base Station
Section4.4.7
Removing a Base Station
To remove a base station from RUGGEDCOM SAS-GW, do the following:
1. Left-click the subscriber unit on the map and then click Edit. The Update Base Station screen appears.
13
14
1
12
2
3
4
5
6
7
8
9
10
11
Figure47:Update Base Station Screen
1.BST Name Box 2.IP Address Box 3.Frequency Start Box 4.Frequency Stop Box 5.Serial Number 6.BST Max Tx Power
Box 7.BST Max EIRP Box 8.SAS Control List 9.Report Measurements to SAS List 10.CBSD Device Category List 11.CBSD
Group List 12.Apply Button 13.Delete Button 14.Deregister from SAS Button
2. Click Delete. A confirmation dialog box appears.