User's Guide

RUGGEDCOM SAS-GW
User Guide
Chapter 4
Configuring RUGGEDCOM SAS-GW
Viewing Available Base Stations 67
3. Click OK. RUGGEDCOM SAS-GW begins de-registering the base station from the SAS and removing it from the
configuration. Allow a few minutes for the process to complete.
Section4.4.8
Viewing Available Base Stations
To view a summary of all base stations, do the following:
• Point to Setup and then click All BS. The View All Base Stations screen appears.
1
2
3
4
Figure48:View All Base Stations Screen
1.Available Base Stations 2.Select Check Box 3.Name Link 4.Edit Link
This table displays the following information for each base station:
Column Description
Name The name assigned to the base station.
The name is hyperlnked. Click the name to view all subscriber units connected to the base station. For
more information, refer to Section4.5.7, “Viewing Available Subscriber Units” .
IP Address The base station's IP address.
Connected CPEs The number of subscriber units connected to the base station.
For more information about how to view a summary of all subscriber units connected to a base station,
refer to Section4.5.7, “Viewing Available Subscriber Units” .
Status The base station's current state.
• Operational – The base station is connected and in full operation
• Unreachable – The base station is not responding to queries
• Connected – The base station is connected, but not transmitting
• NA – The default value of new base stations that have not been configured yet in RUGGEDCOM SAS-
GW
SAS Status The base station's current status with the SAS.
• registered – The device is registered with the SAS
• granted – The SAS granted the last spectrum request
• granted_failed – The SAS denied the last spectrum request
• hb_ok – The SAS is operating normally
• hb_failed – The SAS is not in operation
• relinquished – The SAS accepted the last relinquish request