User's Guide
Table Of Contents
- RUGGEDCOM SAS-GW
- Table of Contents
- Preface
- 1. Introduction
- 2. Installation and Deployment
- 3. Using RUGGEDCOM SAS-GW
- 4. Configuring RUGGEDCOM SAS-GW
- 4.1. Configuring the Local Time Zone
- 4.2. Configuring the SNMP Read/Write Communities
- 4.3. Managing User Accounts
- 4.4. Managing Base Stations
- 4.4.1. Adding a Base Station
- 4.4.2. Updating a Base Station's Configuration
- 4.4.3. Updating a Base Station's Location
- 4.4.4. Updating a Base Station's Antenna Characteristics
- 4.4.5. Updating SNMP Settings
- 4.4.6. Updating CPI Information
- 4.4.7. Removing a Base Station
- 4.4.8. Viewing Available Base Stations
- 4.4.9. Viewing the Measurements Report
- 4.4.10. Viewing the SAS Registration Information
- 4.5. Managing Subscriber Units
- 5. Monitoring RUGGEDCOM SAS-GW
Chapter 4
Configuring RUGGEDCOM SAS-GW
RUGGEDCOM SAS-GW
User Guide
68 Viewing the Measurements Report
Column Description
• relinquished_failed – The SAS denied the last relinquish request
• unregistered – The device is not registered with the SAS
• register_failed – The SAS denied the last registration request
• configuration_error – An error has been detected in the SAS's configuration
Location The base station's latitude and longitude.
Section4.4.9
Viewing the Measurements Report
The measurements report provides information to the SAS about the power received by the device.
To view the measurements report, do the following:
1. Left-click the base station on the map and then click Edit, or open the View All Base Stations list and click
Edit next to the desired base station.
For information about accessing the View All Base Stations list, refer to Section4.4.8, “Viewing Available
Base Stations” .
2
1
Figure49:Editing a Base Station from the Map
Once clicking Edit, the Update Base Station screen appears.