User's Guide
Table Of Contents
- RUGGEDCOM SAS-GW
- Table of Contents
- Preface
- 1. Introduction
- 2. Installation and Deployment
- 3. Using RUGGEDCOM SAS-GW
- 4. Configuring RUGGEDCOM SAS-GW
- 4.1. Configuring the Local Time Zone
- 4.2. Configuring the SNMP Read/Write Communities
- 4.3. Managing User Accounts
- 4.4. Managing Base Stations
- 4.4.1. Adding a Base Station
- 4.4.2. Updating a Base Station's Configuration
- 4.4.3. Updating a Base Station's Location
- 4.4.4. Updating a Base Station's Antenna Characteristics
- 4.4.5. Updating SNMP Settings
- 4.4.6. Updating CPI Information
- 4.4.7. Removing a Base Station
- 4.4.8. Viewing Available Base Stations
- 4.4.9. Viewing the Measurements Report
- 4.4.10. Viewing the SAS Registration Information
- 4.5. Managing Subscriber Units
- 5. Monitoring RUGGEDCOM SAS-GW
Chapter 4
Configuring RUGGEDCOM SAS-GW
RUGGEDCOM SAS-GW
User Guide
70 Viewing the SAS Registration Information
4
2
3
1
Figure51:Measurements Report Tab
1.Received Power 2.Apply Button 3.Delete Button 4.Deregister from SAS Button
The Received Power parameter indicates the power measured and reported to the SAS after spectrum has been
granted to the base station. The number represents the average of the uplink RSSI value reported by all subscriber
stations connected to a base station.
Section4.4.10
Viewing the SAS Registration Information
To view information about the current registration with the SAS, do the following:
1. Left-click the base station on the map and then click Edit, or open the View All Base Stations list and click
Edit next to the desired base station.
For information about accessing the View All Base Stations list, refer to Section4.4.8, “Viewing Available
Base Stations” .