User's Guide
Table Of Contents
- RUGGEDCOM SAS-GW
- Table of Contents
- Preface
- 1. Introduction
- 2. Installation and Deployment
- 3. Using RUGGEDCOM SAS-GW
- 4. Configuring RUGGEDCOM SAS-GW
- 4.1. Configuring the Local Time Zone
- 4.2. Configuring the SNMP Read/Write Communities
- 4.3. Managing User Accounts
- 4.4. Managing Base Stations
- 4.4.1. Adding a Base Station
- 4.4.2. Updating a Base Station's Configuration
- 4.4.3. Updating a Base Station's Location
- 4.4.4. Updating a Base Station's Antenna Characteristics
- 4.4.5. Updating SNMP Settings
- 4.4.6. Updating CPI Information
- 4.4.7. Removing a Base Station
- 4.4.8. Viewing Available Base Stations
- 4.4.9. Viewing the Measurements Report
- 4.4.10. Viewing the SAS Registration Information
- 4.5. Managing Subscriber Units
- 5. Monitoring RUGGEDCOM SAS-GW
RUGGEDCOM SAS-GW
User Guide
Chapter 4
Configuring RUGGEDCOM SAS-GW
Viewing the SAS Registration Information 73
10
8
9
7
6
5
4
3
2
1
Figure54:SAS Registration Info Tab
1.CBSD Status 2.CBSD ID 3.Grant ID 4.Grant Expired Time 5.Transmit Expired Time 6.Available Channel Start
7.Available Channel Stop 8.Apply Button 9.Delete Button 10.Deregister from SAS Button
The SAS Registration Info tab displays the following information:
Parameter Description
CBSD Status The current status of the device. Possible values include:
• Registered – The device is registered with the SAS
• Granted – The SAS granted the last spectrum request
• HB OK – The SAS is operating normally
• Unregistered – The device is not registered with the SAS
CBSD ID The CBRS-wide unique identifier given to the device by the SAS.
Grant ID An ID given to the device by the SAS for the duration of the current grant.
Grant Expired Time The date and time when the current grant is set to expire.
Transmit Expired Time The date and time when permission to transmit expires. The device will stop transmitting 60
seconds after this time.
Available Channel Start The lowest channel in the Spectrum Inquiry Response granted by the SAS.