User's Guide
Table Of Contents
- RUGGEDCOM SAS-GW
- Table of Contents
- Preface
- 1. Introduction
- 2. Installation and Deployment
- 3. Using RUGGEDCOM SAS-GW
- 4. Configuring RUGGEDCOM SAS-GW
- 4.1. Configuring the Local Time Zone
- 4.2. Configuring the SNMP Read/Write Communities
- 4.3. Managing User Accounts
- 4.4. Managing Base Stations
- 4.4.1. Adding a Base Station
- 4.4.2. Updating a Base Station's Configuration
- 4.4.3. Updating a Base Station's Location
- 4.4.4. Updating a Base Station's Antenna Characteristics
- 4.4.5. Updating SNMP Settings
- 4.4.6. Updating CPI Information
- 4.4.7. Removing a Base Station
- 4.4.8. Viewing Available Base Stations
- 4.4.9. Viewing the Measurements Report
- 4.4.10. Viewing the SAS Registration Information
- 4.5. Managing Subscriber Units
- 5. Monitoring RUGGEDCOM SAS-GW
RUGGEDCOM SAS-GW
User Guide
Chapter 4
Configuring RUGGEDCOM SAS-GW
Adding a Subscriber Unit 75
2
1
Figure55:Adding a Subscriber Unit
c. Click Create. The Create New Subscriber Unit screen appears.
1
7
2
3
4
5
6
Figure56:Create New Subscriber Unit
1.CPE Name Box 2.IP Address Box 3.MAC Address Box 4.Serial Number Box 5.SS Max Tx Power Box 6.SS Max
EIRP Box 7.SAS Control List 8.Report Measurements to SAS List 9.CBSD Device Category List 10.CBSD Group List
11.Apply Button
d. Configure the following paramters: