User's Guide
Table Of Contents
- RUGGEDCOM SAS-GW
- Table of Contents
- Preface
- 1. Introduction
- 2. Installation and Deployment
- 3. Using RUGGEDCOM SAS-GW
- 4. Configuring RUGGEDCOM SAS-GW
- 4.1. Configuring the Local Time Zone
- 4.2. Configuring the SNMP Read/Write Communities
- 4.3. Managing User Accounts
- 4.4. Managing Base Stations
- 4.4.1. Adding a Base Station
- 4.4.2. Updating a Base Station's Configuration
- 4.4.3. Updating a Base Station's Location
- 4.4.4. Updating a Base Station's Antenna Characteristics
- 4.4.5. Updating SNMP Settings
- 4.4.6. Updating CPI Information
- 4.4.7. Removing a Base Station
- 4.4.8. Viewing Available Base Stations
- 4.4.9. Viewing the Measurements Report
- 4.4.10. Viewing the SAS Registration Information
- 4.5. Managing Subscriber Units
- 5. Monitoring RUGGEDCOM SAS-GW
Chapter 4
Configuring RUGGEDCOM SAS-GW
RUGGEDCOM SAS-GW
User Guide
78 Adding a Subscriber Unit
Parameter Description
• True – The device is operated indoors
c. Click Apply.
3. Define the characteristics of the subscriber unit's antenna.
a. Click Antenna. The Antenna tab appears.
1
7
2
3
4
5
6
Figure58:Antenna Tab
1.Antenna Azimuth Box 2.Antenna Downtilt Box 3.Gain Box 4.Antenna Type List 5.Beam Width Box 6.Model Box
7.Apply Button
b. Update the following parameters as needed:
Parameter Description
Antenna Azimuth Synopsis: A number between 0 and 359
The angle between true north and the perpendicular projection of the subscriber unit
onto the horizon.
Antenna Downdrift Synopsis: A number between -90 and 90
The degree of beamtilt compared to the horizon. A negative value means the
antenna is tilted up (above horizontal).
Gain Synopsis: A number between -127 and 128
The antenna's peak gain, measured on the decibel logarithmic scale (dBi).
Antenna Type Synopsis: { Omni, Directional }
Default: Omni
The type of antenna used by the subscriber unit. Options include:
• Omni – Omni-directional antenna