User's Guide

Chapter 4
Configuring RUGGEDCOM SAS-GW
RUGGEDCOM SAS-GW
User Guide
82 Updating a Subscriber Unit's Location
Parameter Description
Defines how RUGGEDCOM SAS-GW will handle the subscriber unit. Options include:
• Enabled – The subscriber unit will be reported to the SAS.
• Disabled – The subscriber unit will not be reported to the SAS. However,
RUGGEDCOM SAS-GW will still query the device for its status.
• Off the Grid – The subscriber unit will not be registered or queried.
Report Measurements to SAS Synopsis:  { No Reports, Report after Grant }
Default:  Report after Grant
Controls whether the received power measurement is reported to the SAS. Options
include:
• No Reports – No reports are sent to the SAS
• Report after Grant – Power measurement is reported when spectrum has been
granted
CBSD Category Synopsis:  { a, b }
Default:  a
The CBSD category that applies to all devices behind the RUGGEDCOM SAS-GW. Options
include:
• a – Category A CBSDs are lower power devices that meet all general FCC requirements
and those set forth in sections 96.41 and 96.45 of the FCC's Code of Federal
Regulations (CFR)
• b – Category B CBSDs are higher power devices that meet all general FCC requirements
and those set forth in sections 96.41 and 96.45 of the FCC's Code of Federal
Regulations (CFR)
IMPORTANT!
When a is selected, information about the device installer is required. For
more information, refer to Section4.4.6, “Updating CPI Information” .
CBSD Group Synopsis:  { Disabled, Enabled }
Default:  Disabled
Controls whether grouping parameters are sent with registration requests. Options
include:
• Disabled – Registration requests are sent to the SAS without grouping parameters
• Enabled – Registration requests are sent to the SAS with grouping parameters
3. Click Apply.
Section4.5.3
Updating a Subscriber Unit's Location
To define a subscriber unit's location, do the following:
1. Left-click the subscriber unit on the map and then click Edit. The Update SU screen appears.