User's Guide
Table Of Contents
- RUGGEDCOM SAS-GW
- Table of Contents
- Preface
- 1. Introduction
- 2. Installation and Deployment
- 3. Using RUGGEDCOM SAS-GW
- 4. Configuring RUGGEDCOM SAS-GW
- 4.1. Configuring the Local Time Zone
- 4.2. Configuring the SNMP Read/Write Communities
- 4.3. Managing User Accounts
- 4.4. Managing Base Stations
- 4.4.1. Adding a Base Station
- 4.4.2. Updating a Base Station's Configuration
- 4.4.3. Updating a Base Station's Location
- 4.4.4. Updating a Base Station's Antenna Characteristics
- 4.4.5. Updating SNMP Settings
- 4.4.6. Updating CPI Information
- 4.4.7. Removing a Base Station
- 4.4.8. Viewing Available Base Stations
- 4.4.9. Viewing the Measurements Report
- 4.4.10. Viewing the SAS Registration Information
- 4.5. Managing Subscriber Units
- 5. Monitoring RUGGEDCOM SAS-GW
Chapter 4
Configuring RUGGEDCOM SAS-GW
RUGGEDCOM SAS-GW
User Guide
84 Updating a Subscriber Unit's Location
1
4
2
3
5
Figure64:Location Tab
1.Location Latitude Box 2.Location Longitude Box 3.Location Height Box 4.Height Type List 5.Indoor Deployment List
6.Apply Button 7.Delete Button
3. Update the following parameters as needed:
NOTE
Initial values are based on the subscriber units position on the map.
Parameter Description
Location Latitude Latitudinal position of the subscriber unit's antenna in degrees (°), relative to the World
Geodetic System (WGS) 1984 datum.
Location Longitude Longitudinal position of the subscriber unit's antenna in degrees (°), relative to the World
Geodetic System (WGS) 1984 datum.
Location Height The height of the subscriber unit's antenna above ground level in meters (m).
Height Type Synopsis: { AGL, AMSL }
Default: AGL
Indicates whether the height was measure relative to ground level or sea level. Options
include:
• AGL – Above Ground Level (AGL) indicates the height was measure relative to ground
level
• AMSL – Above Mean Sea Level (AMSL) indicates the height was measure relative to sea
level
Indoor Deployment Synopsis: { False, True }
Default: False
Indicates whether or not the device is operated indoors or outdoors. Options include:
• False – The device is operated outdoors
• True – The device is operated indoors
4. Click Apply.