User's Guide
Table Of Contents
- RUGGEDCOM SAS-GW
- Table of Contents
- Preface
- 1. Introduction
- 2. Installation and Deployment
- 3. Using RUGGEDCOM SAS-GW
- 4. Configuring RUGGEDCOM SAS-GW
- 4.1. Configuring the Local Time Zone
- 4.2. Configuring the SNMP Read/Write Communities
- 4.3. Managing User Accounts
- 4.4. Managing Base Stations
- 4.4.1. Adding a Base Station
- 4.4.2. Updating a Base Station's Configuration
- 4.4.3. Updating a Base Station's Location
- 4.4.4. Updating a Base Station's Antenna Characteristics
- 4.4.5. Updating SNMP Settings
- 4.4.6. Updating CPI Information
- 4.4.7. Removing a Base Station
- 4.4.8. Viewing Available Base Stations
- 4.4.9. Viewing the Measurements Report
- 4.4.10. Viewing the SAS Registration Information
- 4.5. Managing Subscriber Units
- 5. Monitoring RUGGEDCOM SAS-GW
Chapter 4
Configuring RUGGEDCOM SAS-GW
RUGGEDCOM SAS-GW
User Guide
88 Updating the Frequency Spectrum
4. [Optional] Configure the following additional parameter:
Parameter Description
Model Synopsis: A string between 1 and 128 characters
The platform name or part number of the antenna (e.g. WIN5137).
5. Click Apply.
Section4.5.5
Updating the Frequency Spectrum
To update the frequency spectrum in which the subscriber unit operates, do the following:
1. Left-click the subscriber unit on the map and then click Edit. The Update SS screen appears.
Figure68:Update SS Screen
2. Select the Spectrum tab. The Spectrum tab appears.