User's Manual

WiN7000 cBST Installation Procedures | 36
4.3.2 Wall Mount
Figure 4-7: WiN7000 – Wall Mount
To install the WiN7000 on a wall:
1. Select a mounting location on the wall.
2. Place the mounting bracket on the wall and mark the location of four holes (two at the
top and two at the bottom).
3. Drill the four holes for the fastening inserts (use 5/16 inch drill).
4. Insert the fastening inserts type NC ¼ into the holes.
5. Insert four flat washers, four spring washers, four screws type NS1/4 X ½ HEX via the
holes on the mounting bracket.
6. Attach the mounting bracket at this location.
7. Fasten the screws.
8. Hold the WiN7000 by the ears on both sides and slide it into the mounting bracket with
care.
9. The ears should match the ridge of the mounting bracket.