User's Manual

Installation Procedure

WiN7200 Installation and Setup Guide

3.3 Required Tools and Materials

In order to install the Pico BST, a standard professional toolbox is required.

3.4 Installing the Pico BST

Note: Should be installed at highest possible point!

Important!

The equipment should be installed in compliance with the National Electrical Code (NEC),

ANSI/NFPA 70, the Canadian Electrical Code (CEC), Part 1, CSA C22.1; and when applicable, the

National Electrical Safety Code IEEE C2. Unless marked or otherwise identified, the Standard for

the Protection of Electronic Computer/Data Processing Equipment, ANSI/NFPA 75.

There are two types of installations for the Pico BST:

• Wall mount - The Pico BST can be attached to any wall that can support the load of the

unit.

• Pole mount - The unit can be attached to any pipe or pole with diameter 1.75” to 10".

3.4.1 Overview

The Pico BST installation procedure consists of the following steps:

1. Covering the Console port (only used for maintenance purposes by authorized personnel) –

see

3.4.2.

2. Assembling the PoE connector – see

3.4.3.

3. Assembling the Pico BST mounting bracket – see

3.4.4.

4. Mounting the Pico BST (wall/pole mount) – See

3.4.5.

5. Antenna connections and grounding – see

3.4.6.

6. Connecting the Win7200 Data Adapter – see

3.4.7.

7. See chapter

4 for the initial Setup procedure.