Manualshelf

User's Manual

ManualsBrandsSiemens Canada ManualsElectronicsPico Base station transceiver
11121314151617181920
Installation Procedure
WiN7200 Installation and Setup Guide
19
4. Align the cap ridge with slot in port and insert both screws into the cover screw holes and
insert in to corresponding screw holes located at the top-left and bottom-right of the
DC/Ethernet port.
5. Tighten the screws and secure cover to port.
3.4.4 Assemble Mounting Bracket
To assemble the mounting bracket on the Pico BST unit
1. Align the mounting brackets’ four inner holes with the Pico BST installation holes, located on
the under-side of the unit (rib-side). See figure below.
2. Using a Phillips screwdriver, secure the bracket to the Pico BST unit with the four screws and
washers (supplied).
Slo