User's Manual
Table Of Contents
- RUGGEDCOM WIN5158-AC-IS
- Table of Contents
- Preface
- 1. Introduction
- 2. Installing the Device
- 2.1. Mounting the Device
- 2.2. Installing the Antenna
- 2.3. Assembling the PoE Cable
- 2.4. Connecting the WIN1010 Data Adapter
- 2.5. Connecting to a RUGGEDCOM RP100 or RP110 (AC Only)
- 2.6. Installing the Device in Hazardous Locations
- 2.7. Grounding the Device
- 2.8. Weatherproofing the Device
- 2.9. Configuring the CPE
- 3. Technical Specifications
- 4. Dimension Drawings
- 5. Certification
RUGGEDCOM WIN5158-AC-IS
Installation Guide
Chapter 1
Introduction
Configuration Ports and Indicator LEDs 3
Section 1.2
Configuration Ports and Indicator LEDs
Connectors and LED indicators are found on the bottom of the device casing.
RUGGEDCOM WIN5158-AC-IS
2
1
3
4
Figure 1: RUGGEDCOM WIN5158-AC-IS Connectors
1. ANT1 2. ANT2 3. Ground 4. ETH/PWR
Name Description Connector Type
ETH/PWR Data and power from PoE injector RJ-45
ANT1 Antenna 1 N-Type female
ANT2 Antenna 2 N-type female
Ground Ground Grounding screw
LED Indicators
The LED indicators display the following information:
• RSSI: displays the Received Signal Strength Indicator (RSSI) level
• W.LNK: displays the wireless link indication
• PWR: displays the power status
The following table displays the LED indicators for the device:
LED Color Description
WLNK is ON Green
The device is connected with and
receives services from the base
station; network entry is complete.
WLNK is BLINKING Green
The link between the CPE and the
base station is down.
PWR is ON Green CPE power is on.