User's Manual
Table Of Contents
- RUGGEDCOM WIN5158-AC-IS
- Table of Contents
- Preface
- 1. Introduction
- 2. Installing the Device
- 2.1. Mounting the Device
- 2.2. Installing the Antenna
- 2.3. Assembling the PoE Cable
- 2.4. Connecting the WIN1010 Data Adapter
- 2.5. Connecting to a RUGGEDCOM RP100 or RP110 (AC Only)
- 2.6. Installing the Device in Hazardous Locations
- 2.7. Grounding the Device
- 2.8. Weatherproofing the Device
- 2.9. Configuring the CPE
- 3. Technical Specifications
- 4. Dimension Drawings
- 5. Certification
Chapter 1
Introduction
RUGGEDCOM WIN5158-AC-IS
Installation Guide
4 Antennas
LED Color Description
RSSI: one LED is ON (least
significant)
Green RSSI < -90
RSSI: two LEDs are ON Green -85 < RSSI < -90
RSSI: three LEDs are ON Green -80 < RSSI < -85
RSSI: four LEDs are ON Green -75 < RSSI < -80
RSSI: five LEDs are ON Green -70 < RSSI < -75
RSSI: six LEDs are ON Green -65 < RSSI < -70
RSSI: seven LEDs are ON
Older Hardware
LEDs 1-7: Green
LED 8: Red
Latest Hardware
LEDs 1-6: Green
LED 7: Red
-20 < RSSI < -60
RSSI: only the last LED is ON
(most significant)
Red -20 < RSSI (Saturation)
RUGGEDCOM WIN1010 Data Adapter LED Indicators
LEDs on the WIN1010 data adapter indicate the status of the WIN1010 power supply.
Name Color Description
PWR Green Input power is connected
LAN Green LAN link/activity display
WLNK Green Wireless link/activity display
Section 1.3
Antennas
The CPE consists of the following modules:
Module Description
Base-Band board: Includes the WiMAX 16e MIMO Base-Band SoC and runs the 16e
MAC + PHY, user interface, and analog front end interface to the RF
module.
Power Supply board with DC/DC power supply: Converts 48 VDC input to the voltages feeding the Digital and RF
modules.
RF board: Single transmit/dual receive module that modulates the analog
WiMAX signal input from the Base-Band modem to the high
frequency RF output. Several RF modules exist, each supporting a
different frequency band.
Chassis