User's Manual
Table Of Contents
- RUGGEDCOM WIN5158-AC-IS
- Table of Contents
- Preface
- 1. Introduction
- 2. Installing the Device
- 2.1. Mounting the Device
- 2.2. Installing the Antenna
- 2.3. Assembling the PoE Cable
- 2.4. Connecting the WIN1010 Data Adapter
- 2.5. Connecting to a RUGGEDCOM RP100 or RP110 (AC Only)
- 2.6. Installing the Device in Hazardous Locations
- 2.7. Grounding the Device
- 2.8. Weatherproofing the Device
- 2.9. Configuring the CPE
- 3. Technical Specifications
- 4. Dimension Drawings
- 5. Certification
RUGGEDCOM WIN5158-AC-IS
Installation Guide
Chapter 2
Installing the Device
Mounting the Device to a Pole 9
NOTE
For detailed dimensions of the device, refer to Chapter 4, Dimension Drawings.
The following sections describe the various methods of mounting the device, and how to install the mounting
bracket:
• Section 2.1.1, “Mounting the Device to a Pole”
• Section 2.1.2, “Mounting the Device to a Wall or Tower”
The RUGGEDCOM WIN5158-AC-IS ODU CPE mounting kit allows for pole or wall mounting.
When choosing the mounting location for the unit, consider the available mounting structures and antenna
clearance.
Site Survey
Most wireless networks include many CPEs and BSTs installed in various locations in an overlapping radio-
cell pattern. It is important to position each CPE at an optimal location considering the assignment of its radio
channels. Therefore, a site survey becomes an essential first step before physically deploying the RUGGEDCOM
WIN5158-AC-IS solution.
The site survey should include details important to the planning of the CPE deployment in each specific site,
including potential mounting points for CPE and antennas, as well as the routing options for data, power and
antenna cables.
Recommended Site Requirements
It is highly recommended the RUGGEDCOM WIN5158-AC-IS be mounted with as few obstructions as possible
between the CPE and the base station. The CPE should be pointed in the direction of the designated server base
station. When choosing the ideal location, it is also important to take into consideration the overall area topology.
Section 2.1.1
Mounting the Device to a Pole
The device can be attached to any pipe or pole with a diameter of 44.5 to 254 mm (1.75 to 10 in).
To mount the device to a pole, do the following:
1. Select a mounting location on the pole.
2. Position the mounting bracket against the pole.
3. Secure the clamping bracket to the mounting bracket using screws, spring washers and nuts. Make sure the
screws are hand tightened.
NOTE
When mounting the device, note the orientation of the clamping bracket in the illustration.