User's Manual
Table Of Contents
- RUGGEDCOM WIN7000
- Table of Contents
- FCC Statement and Cautions
- 1. Introduction
- 1.1. About this Guide
- 1.2. Capabilities and Features
- 1.3. Safety Information
- 1.3.1. General
- 1.3.2. Power Supply Requirements
- 1.3.3. Equipment Installation
- 1.3.4. Radio Frequency (RF) Exposure
- 1.3.5. Lightning Protection
- 1.3.6. Power Cord Protection
- 1.3.7. Servicing
- 1.3.8. Antenna Grounding Requirements
- 1.3.9. Outdoor Grounding System
- 1.3.10. User Ports and Power Supply
- 1.3.11. Safety Hazards
- 1.4. WIN7000 Physical Specifications
- 2. Site and Installation Requirements
- 3. Installation Procedures
- 3.1. Pre-Installation Safety Instructions
- 3.2. Package Components and Unpacking
- 3.3. Installation Tools
- 3.4. Installing the Base Station
- 3.5. Weatherproofing
- 3.6. Hazardous Location Information
- 3.7. Hazardous Location Installation
- 4. Setup
- 5. Troubleshooting
- Appendix A. Connector and Cable Pinouts
- Appendix B. WIN7000 Specifications
- Appendix C. List of Acronyms
- Appendix D. Warranty
Chapter 3
Installation Procedures
RUGGEDCOM WIN7000
Installation Guide
12 Pole Mounting
Section 3.4.3
Pole Mounting
Figure 6: WIN7000 Pole Mounting Diagram
Table: WIN7000 Pole Mount Parts List
Item Quantity Description
1 1 Mounting brackets
2 1 WIN7000
3 2 Fastening brackets
4 4 Screw 5/16" hex cap × 6"
5 8 Nut NF 16 hex
6 10 Washer flat 5/16"
7 10 Washer spring 5/16"
8 4 Screw NC 1/4" × 1/2" hex
9 4 Washer flat NC 1/4"
10 4 Washer spring NC 1/4
11 1 Pole
12 2 Bolt NC 1/4"
13 2 Screw NC 5/16" × 1/2"
14 1 Mounting Upper Bracket