User's Manual
Table Of Contents
- RUGGEDCOM WIN7000
- Table of Contents
- FCC Statement and Cautions
- 1. Introduction
- 1.1. About this Guide
- 1.2. Capabilities and Features
- 1.3. Safety Information
- 1.3.1. General
- 1.3.2. Power Supply Requirements
- 1.3.3. Equipment Installation
- 1.3.4. Radio Frequency (RF) Exposure
- 1.3.5. Lightning Protection
- 1.3.6. Power Cord Protection
- 1.3.7. Servicing
- 1.3.8. Antenna Grounding Requirements
- 1.3.9. Outdoor Grounding System
- 1.3.10. User Ports and Power Supply
- 1.3.11. Safety Hazards
- 1.4. WIN7000 Physical Specifications
- 2. Site and Installation Requirements
- 3. Installation Procedures
- 3.1. Pre-Installation Safety Instructions
- 3.2. Package Components and Unpacking
- 3.3. Installation Tools
- 3.4. Installing the Base Station
- 3.5. Weatherproofing
- 3.6. Hazardous Location Information
- 3.7. Hazardous Location Installation
- 4. Setup
- 5. Troubleshooting
- Appendix A. Connector and Cable Pinouts
- Appendix B. WIN7000 Specifications
- Appendix C. List of Acronyms
- Appendix D. Warranty
Chapter 3
Installation Procedures
RUGGEDCOM WIN7000
Installation Guide
20 SFD Type Base Station
Figure 14: Fiber Optic Ethernet Port Option
4. Connect the optical cable to the network switch (for more information, see Figure 15).
NOTE
The fiber optic standard is Gigabit Ethernet 1000 Base-LX.
Figure 15: Base Station Power Connection
Table: +48 VDC Power System
Supplied Cable Power Supply Note
-48VDC -48VDC GND
+48VDC +48VDC/ GND “HOT Line”
GND -48VDC/ GND Connect -48V and GND
Table: -48 VDC Power System
Supplied Cable Power Supply Note
-48VDC -48VDC “HOT Line”
+48VDC +48VDC/ GND GND