User's Manual
Table Of Contents
- RUGGEDCOM WIN7000
- Table of Contents
- FCC Statement and Cautions
- 1. Introduction
- 1.1. About this Guide
- 1.2. Capabilities and Features
- 1.3. Safety Information
- 1.3.1. General
- 1.3.2. Power Supply Requirements
- 1.3.3. Equipment Installation
- 1.3.4. Radio Frequency (RF) Exposure
- 1.3.5. Lightning Protection
- 1.3.6. Power Cord Protection
- 1.3.7. Servicing
- 1.3.8. Antenna Grounding Requirements
- 1.3.9. Outdoor Grounding System
- 1.3.10. User Ports and Power Supply
- 1.3.11. Safety Hazards
- 1.4. WIN7000 Physical Specifications
- 2. Site and Installation Requirements
- 3. Installation Procedures
- 3.1. Pre-Installation Safety Instructions
- 3.2. Package Components and Unpacking
- 3.3. Installation Tools
- 3.4. Installing the Base Station
- 3.5. Weatherproofing
- 3.6. Hazardous Location Information
- 3.7. Hazardous Location Installation
- 4. Setup
- 5. Troubleshooting
- Appendix A. Connector and Cable Pinouts
- Appendix B. WIN7000 Specifications
- Appendix C. List of Acronyms
- Appendix D. Warranty
RUGGEDCOM WIN7000
Installation Guide
Chapter 3
Installation Procedures
Grounding the Device 21
Supplied Cable Power Supply Note
GND +48VDC/ GND Connect +48V and GND
Section 3.4.7
Grounding the Device
To ground the device, do the following:
Procedure: Grounding the Device
1. Assemble the ground connection as shown:
6
52
3
4
3
21
Figure 16: Ground Cable Assembly
1. Ground Stud 2. Flatwasher 3. External Tooth Lockwasher 4. 10 AWG Isolated Ring 5. Nut 6. 10 AWG Ground Wire
2. Using a 1/4" square drive socket, torque the nut to 8.5 N·m (75 lbf-in).
Section 3.4.8
Installing the GPS Antenna
To install the GPS antenna, do the following:
Procedure: Installing the GPS Antenna
1. Mount the GPS antenna as shown in Figure 17.