User's Manual
Table Of Contents
- RUGGEDCOM WIN7000
- Table of Contents
- FCC Statement and Cautions
- 1. Introduction
- 1.1. About this Guide
- 1.2. Capabilities and Features
- 1.3. Safety Information
- 1.3.1. General
- 1.3.2. Power Supply Requirements
- 1.3.3. Equipment Installation
- 1.3.4. Radio Frequency (RF) Exposure
- 1.3.5. Lightning Protection
- 1.3.6. Power Cord Protection
- 1.3.7. Servicing
- 1.3.8. Antenna Grounding Requirements
- 1.3.9. Outdoor Grounding System
- 1.3.10. User Ports and Power Supply
- 1.3.11. Safety Hazards
- 1.4. WIN7000 Physical Specifications
- 2. Site and Installation Requirements
- 3. Installation Procedures
- 3.1. Pre-Installation Safety Instructions
- 3.2. Package Components and Unpacking
- 3.3. Installation Tools
- 3.4. Installing the Base Station
- 3.5. Weatherproofing
- 3.6. Hazardous Location Information
- 3.7. Hazardous Location Installation
- 4. Setup
- 5. Troubleshooting
- Appendix A. Connector and Cable Pinouts
- Appendix B. WIN7000 Specifications
- Appendix C. List of Acronyms
- Appendix D. Warranty
RUGGEDCOM WIN7000
Installation Guide
Chapter 3
Installation Procedures
Weatherproofing Cable Connections 33
Figure 31: Sealing Gaps with Putty
5. Apply two layers of electrical tape over the rubber splicing tape for UV protection.
Figure 32 and Figure 33 show the base station connectors wrapped with splicing and electrical tape, before the
application of mastic or duct sealing putty.
Figure 32: Wrapped Connectors before the application of Weathproofing Putty