User's Manual
Table Of Contents
- RUGGEDCOM WIN7000
- Table of Contents
- FCC Statement and Cautions
- 1. Introduction
- 1.1. About this Guide
- 1.2. Capabilities and Features
- 1.3. Safety Information
- 1.3.1. General
- 1.3.2. Power Supply Requirements
- 1.3.3. Equipment Installation
- 1.3.4. Radio Frequency (RF) Exposure
- 1.3.5. Lightning Protection
- 1.3.6. Power Cord Protection
- 1.3.7. Servicing
- 1.3.8. Antenna Grounding Requirements
- 1.3.9. Outdoor Grounding System
- 1.3.10. User Ports and Power Supply
- 1.3.11. Safety Hazards
- 1.4. WIN7000 Physical Specifications
- 2. Site and Installation Requirements
- 3. Installation Procedures
- 3.1. Pre-Installation Safety Instructions
- 3.2. Package Components and Unpacking
- 3.3. Installation Tools
- 3.4. Installing the Base Station
- 3.5. Weatherproofing
- 3.6. Hazardous Location Information
- 3.7. Hazardous Location Installation
- 4. Setup
- 5. Troubleshooting
- Appendix A. Connector and Cable Pinouts
- Appendix B. WIN7000 Specifications
- Appendix C. List of Acronyms
- Appendix D. Warranty
RUGGEDCOM WIN7000
Installation Guide
Appendix B
WIN7000 Specifications
45
WIN7000 Specifications
Radio and Modem:
• Frequency, by Base Station model number:
▪ WIN7023: 2300 MHz to 2400 MHz
▪ WIN7025: 2496 MHz to 2690 MHz
▪ WIN7035: 3400 MHz to 3600 MHz
▪ WIN7015: 1400 MHz to 1520 MHz
▪ WIN7018: 1800 MHz to 1830 MHz
• IEEE802.16-2005 (16e OFDMA)
• WiMAX Forum Wave 2 Profile
• Time Division Duplex (TDD)
• Channel Bandwidth (MHz) 3.5, 5, 7, 10
• Frequency Resolution 0.25 MHz
• Diversity Support 2x2, STC/MIMO-SM
• FEC Convolution Code and Turbo Code
• Transmit Power Control
• Output Power (average) 2 X 36 dBm
• Modulation 512/1024 FFT points; QPSK, 16QAM, 64QAM
Radio Interfaces:
• Number of Antennas: 2
• Antenna Connectors 2 × N-Type, 50 ohm
• Integrated or External Sector or Omni Antenna
• Built-in GPS included
Network Interfaces:
• 10/100BaseT Half/Full Duplex IEEE 802.3 CSMA/CD
• ASN GW Compatibility WiMAX Forum R6, Profile C
• Compatible with Cisco and WiChorus ASN-GW
• Fiber Optic (Optional)
Configuration and Management:
• Web GUI
• Management SNMP
• SNMP Agent SNMP ver 2 client/v3
• Software Upgrade via FTP, SFTP
• Remote Configuration via FTP, SFTP