User's Manual
Table Of Contents
- RuggedMAX™ WiN7200 Small Form Factor Base Station
- Table of Contents
- FCC Statement And Cautions
- 1. About This Guide
- 2. Introduction
- 3. Site and Installation Requirements
- 4. Installation Procedures
- 4.1. Pre-Installation Safety Instructions
- 4.2. Package Components and Unpacking
- 4.3. Required Tools and Materials
- 4.4. Installing the Base Station
- 4.5. Hazardous Location Installation
- 5. Setup
- 6. Troubleshooting
- Appendix A. List of Acronyms
- Appendix B. WiN7200 Small Form Factor Base Station Specifications
- Appendix C. IDU to ODU Cable Specifications
- Appendix D. Console Connector Specifications
- Appendix E. WiN7200 Small Form Factor Base Station Base Station Mechanical Drawing
- Appendix F. Warranty
2. Introduction
RuggedMAX™ 13 Installation Guide Rev 1.0
2.4. Interfaces
Install the unit vertically, with the integrated GPS antenna located on the top panel (facing the
sky). All other connections, including the optional GPS external antenna connections are located
on the bottom panel.
2.4.1. Bottom Panel
The interface panel supports the antenna, power and Ethernet connections.
Figure 2.3. WiN7200 Small Form Factor Base Station Interface Panel
The following table provides a description of the base station bottom panel connectors and ports.
Connector Name Connector Type Cable Type Function Connected to
ANT1 N typeFemale RG 214/U RF antenna connection
External antenna or
screwed-on omni-directional
antenna
CONSOLE RJ45 Cat5 ETH
Low level CLI for technical
personnel. RS-232
Computer
DC/ETH RJ45 Cat5 ETH DC 1.5A + Ethernet Cat5 PoE data adaptor
GND 1 screwETSI
#10 AWG bare
copper wire
Grounding lug. #10 AWG
bare copper wire
Central earth ground, tower
or pole chassis
GPS (optional) TNCFemale RG-59
Base Station
Synchronization
External GPS antenna
ANT2 N typeFemale RG 214/U RF antenna connection
External antenna or
screwed-on omni-directional
antenna
Table 2.1. WiN7200 Small Form Factor Base Station Interface Connectors