User's Manual
Table Of Contents
- RuggedMAX™ WiN7200 Small Form Factor Base Station
- Table of Contents
- FCC Statement And Cautions
- 1. About This Guide
- 2. Introduction
- 3. Site and Installation Requirements
- 4. Installation Procedures
- 4.1. Pre-Installation Safety Instructions
- 4.2. Package Components and Unpacking
- 4.3. Required Tools and Materials
- 4.4. Installing the Base Station
- 4.5. Hazardous Location Installation
- 5. Setup
- 6. Troubleshooting
- Appendix A. List of Acronyms
- Appendix B. WiN7200 Small Form Factor Base Station Specifications
- Appendix C. IDU to ODU Cable Specifications
- Appendix D. Console Connector Specifications
- Appendix E. WiN7200 Small Form Factor Base Station Base Station Mechanical Drawing
- Appendix F. Warranty
Appendix B. WiN7200 Small Form Factor Base Station Specifications
RuggedMAX™ 33 Installation Guide Rev 1.0
• Weight <4kg
Power Interface:
• Power supply Input 85-265 VAC
• Power Consumption 30 W max
Environmental:
• Operating Temperature: -40°C to +65°C
• Operating Humidity 5%-95% non condensing,
• Weather protected
Standards Compliance:
• EMC FCC part 15, subpart B, class B
• ETSI EN 301489-1/4
• Safety TUV-UL 60950-1
• IEC 60950-1
• Environmental ETS 300 019:
• Part 2-1 T 1.2 & part 2-2 T 2.3
• Part 2-4 T 4.1E
• IP66
Immunity
• EN61000-4-2
• EN61000-4-4
• EN61000-4-5
• Radio FCC Part 27
• FCC Part 90
• ETSI EN302 326
Supported Subscriber Units:
• Outdoor unit with integrated antenna
• Indoor unit with integrated Voice over IP
• USB dongle
• Vehicular subscriber unit