User's Manual
Table Of Contents
- Contents
- List of Tables
- List of Figures
- 1 Introduction and Important Notes
- 2 Overview
- 3 Planning a HiPath Cordless IP System
- 3.1 Planning According to Call Traffic Load
- 3.2 General
- 3.3 Propagation Conditions for Radio Traffic
- 3.4 Determining the Installation Site
- 3.5 Installing Base Stations
- 4 Putting Into Service
- 5 Installation and Administration
- 5.1 Terminology
- 5.2 Network Concept
- 5.3 Synchronisation over air concept
- 5.4 WBM related issues
- 5.5 Phone related issues
- 5.6 Partition concept of BSIP1
- 5.7 Factory reset of BSIP1
- 5.8 Release notes
- 5.9 Quick Start
- 5.10 Quick start overview
- 5.11 Prepare and connect hardware
- 5.12 Configure BSIP1 for IWU mode
- 5.13 Configuration of VoIP (Infrastructure) network
- 5.14 Configuration of DECT network
- 5.15 Configuration of users at the PBX
- 5.16 Configuration of users at the BSIP IWU
- 5.17 Start system services and register handsets
- 5.18 Configure further BSIP Only to the system
- 5.19 "Quick Start" Completion
- 5.20 Further steps
- 5.21 Configuration reference
- 5.22 WBM overview
- 5.23 Administration
- 5.24 "Network/Gateways" Configuration
- 5.25 "Group" Configuration
- 5.26 Users Configuration
- 5.27 Dect Configuration
- 5.27.1 Configuration Page "Dect - Device"
- 5.27.2 Configuration Page "Dect - Sync"
- 5.27.3 Configuration Page "Dect - ARI"
- 5.27.4 Configuration Page "Dect - About"
- 5.27.5 Configuration Page "Dect - Radio" (Advanced mode)
- 5.27.6 Configuration Page "Dect - Call" (Advanced mode)
- 5.27.7 Configuration Page "Dect - Debug" (Advanced mode)
- 5.27.8 General DECT configuration
- 5.28 Debugging Configuration
- 5.29 "Status" Configuration
- 5.30 "System" Configuration
- 5.31 Configuration Hints for PBXs
- 5.32 HiPath OpenOffice EE
- 5.33 HiPath OpenOffice ME
- 5.34 Troubleshooting / FAQ
- 5.35 Configuration hints for Web Browser
- 6 Technical Data
- 7 Diagnosis and Maintenance
- 8 Open Source Software used in the Product
- Index
Installation and Administration
c05_ikon.fm
Configuration hints for Web Browser
A31003-C1010-S100-2-7620, 08/2010
146 HiPath Cordless IP, Service Manual
5.35.2 Microsoft Internet Explorer
The following version of Microsoft Internet Explorer are supported:
• Version 6.x
• Version 7.x
The minimum supported screen resolution the Browser is running on is
1024x768.
Please keep in mind that the support of IE starts with a running version of BSIP1
v_3.24.3. Updating to version 3.24.3 has to be done with Firefox.
Depending of the security settings of MS IE, the IP address of the BSIP1 has to
be added to the list of Trusted sites (Tools - Internet options - Security - Trusted
sites).
This comes in effect when Backing up a configuration file. If the security settings
are not valid, the configuration file will not be donloaded and the WBM session
will be closed.
For IE7 there is an issue one some installations when backing up the configu-
ration. After initiating the backup process, the information panel will be displayed
and afterwards you are logged out from the WBM. To overcome this situation, you
have to change the following settings in IE7:
1. Select Tools - InternetOptions - Security
2. Select the appropriate zone in which the IWU is located (e.g. "Trusted
sites") and select [Custom level]
3. In the outline view browse to "Downloads" and change the setting of
"Automatic prompting for file downloads" from Disabled to Enabled.