User's Manual

Wireless Remote Control
AXB4-310.621.01.02.02 7 / 12
DRAFT
’Center lock’ tracking
Disable/enable ’center lock’ tracking
– Press the ’center lock’ tracking button just for a short time (< 3 s) to activate
or deactivate center-lock tracking at the current position.
When an OGP with centered tracking is selected press the tracking button
longer than 3 s and keep it pressed (dead man switch). Detector and tube
unit are then centered as programmed.
– LED at tube support control panel lights up when tracking is active
– LED at tube support control panel flashes when tracking is not possible or
being in progress
SID tracking
Disable/enable SID tracking control
– Press: The tracking control is switched off(on).
– LED at tube support control panel lights up when tracking is active
– LED at tube support control panel flashes when tracking is not possible or
being in progress
Parking position
Switching over the function of the OGP button to parking position
– Green LED is on.
After having reached the parking position, immediately switch off this function
again.
– Green LED is off.
Marking signs
The Wireless Remote Control is marked with a colored sign of different shape to
avoid a mix up for installations with a multitude of Wireless Remote Control. The
same marks are attached to the respective table and room during installation.
These are two examples of colored signs of different shape to mark the remote
control to an x-ray system.