User Manual

Logical I/O blocks
General functions
19
CM110664en_07 247 | 353
Override via client
The input, output and value blocks can be overridden via BACnet clients or in
XWP (CFC) in online test mode.
There are two options:
1. Override via a BACnet client:
A BACnet client is overridden with a BACnet service.
Input objects are overridden by setting the out-of-service parameter [OoServ]
and writing the desired present value [PrVal]. The default value [DefVal] is
automatically set to the same value as [PrVal]. (You can also overwrite
[DefVal], in which case [PrVal] is automatically used instead).
There is no need to follow these rules when using the PXM20 to override a
value, as the operator unit observes them automatically.
Overridden input objects are not reset automatically. To do this, reset [OoServ]
first. [DefVal] remains at the last overridden value and [PrVal] is again derived
from the physical input.
2. Override via online test mode in CFC:
Overrides with CFC are carried out via a proprietary service.
Outputs of a block cannot be overwritten.
To overwrite [PrVal] the out of service state in [OoServ] must be set to TRUE,
after which the default value [DefVal] can be modified. This value is then
adopted (or applied) as the present value and is made available under [PrVal].
PXM30/40/50PXM20
Online test mode
in PX Design
Web client
User override of an
input value