User Manual

Desigo workflow, tools and programming
Programming in D-MAP
4
54 | 353 CM110664en_07
ABT Site > Configuration
In ABT Site > Configuration you configure preloaded application types or
project-specific types.
ABT Site > Startup
In ABT Site > Startup you scan networks, load configurations and read back
parameters.
ABT-SSA
In ABT-SSA (Setup & Service Assistant) you commission I/Os and carry out the
point test.
See
Desigo TRA - Setup & Service Assistant (CM11105).
In ABT-SSA you can:
● Assign network points (DALI to device), make points available
● Test if the points work
● Define parameters, e.g., time, desired value, default value, etc.
4.13 Programming in D-MAP
Programming is based on D-MAP principles (Desigo Modular Application
Programming), where you assemble blocks into compounds and then you build
hierarchically structured solutions using those compounds.
● In Xworks Plus (XWP) you program in the CFC Classic editor.
● In the Automation Building Tool (ABT) you program in the CFC Plus editor.
The CFC editors have a different look and feel. Their basic functions and basic
library blocks are almost identical.
Programming in XWP for Desigo PX
The Program View describes the concepts and elements on which D-MAP is
based: libraries, compounds, blocks, variables, data types and attributes.
The P&I diagram
The Program View is based on the P&I (Process & Instrumentation) diagram.
The P&I diagram illustrates the plant and the associated instrumentation in the
form of a principles diagram.
The following figure shows a simplified P&I diagram of a partial air conditioning
system. The heating coil and its components, including the automation station
sequence, are encircled.