User Manual

30/118
Siemens TX-I/O Engineering and installation guide CM110562en_13
Building Technologies TX-I/O™ mounting instructions 2019-05-15
U1
N1
ON
ON
BT
BM
U2
ON
ON
BT
BM
U2
U4
U1
ON
ON
BT
BM
U2
ON
ON
BT
BM
U2X1
C C CAS B
N2
P-Bus
10562z150_02
U1
ON
ON
BT
BM
U2
U5
N3
PROFINET
ON
ON
BT
BM
U2
N1
A C C CAS B
Key
N1 Room automation station or
Automation station with island
bus
N2 Automation station with P-bus
N3 Simatic S7 300 / 400
U4 P-Bus-BIM (Bus interface
module)
with built-in supply
U5 PROFINET BIM
U1 TXS1.12F10 power supply
module
U2 TXA1.IBE Island bus expansion
module (optional)
X1 TXS1.EF10 bus connection
modules
Each I/O row is connected from left to right (or from top to bottom) by mounting the
devices vertically one after the other on the standard mounting rail.
The island bus is created automatically in this process.
• The first item mounted on each I/O row must be the device or devices that deliver
the bus signal, the module power supply and the field device supply (e.g. a power
supply module)
– Pull the slide-fitting outwards (1)
– Press the device onto the rail (2)
– Push the slide-fitting back into place (3)
• The I/O module assemblies can then be plugged in one after the other (4), (5).
10762J017
1
2
3
5
4