User Manual

6/118
Siemens TX-I/O Engineering and installation guide CM110562en_13
Building Technologies Introduction 2019-05-15
1.3 Other applicable documents
Document
Number
[1]
TX-I/O™ Range overview CM2N8170
[2]
TX-I/O™ Module data sheets CM2N8172 ff
[3]
TX-I/O™ Power supply module / bus connection module data sheet CM2N8183
[4]
TX-I/O™ Functions and operation CM110561
[5]
P-bus bus interface module data sheet
CM2N8180
[6]
PROFINET BIM data sheet CM2N8186
[7]
Replacement of legacy modules
CM110563
[8]
Island bus expansion module
CM2N8184
[9]
PROFINET BIM Operator's manual
CM110564
[10]
PXC3... data sheet
CM1N9203
The documents listed in the table are available on the intranet via the document
information system, STEP.
1.4 Before you start
This document may be duplicated and distributed only with the express permission of
Siemens, and may be passed only to authorized persons or companies with the
required technical knowledge.
These documents have been prepared with great care.
• The contents of all documents are checked at regular intervals.
• Any corrections necessary are included in subsequent versions.
• Documents are automatically amended as a consequence of modifications and
corrections to the products described.
Please ensure that you are aware of the latest revision date of the documentation.
If you find any lack of clarity while using this document, or if you have any criticisms or
suggestions, please contact the product manager in your nearest branch office.
The addresses of the Siemens regional companies are available at
www.buildingtechnologies.siemens.com
.
Before using our products, it is important that you read the documents supplied with or
ordered at the same time as the products (equipment, applications, tools etc.) carefully
and in full.
We assume that persons using our products and documents are authorized and trained
appropriately and have the technical knowledge required to use our products as
intended.
More information on the products and applications is available:
• On the intranet (Siemens employees only) at
https://workspace.sbt.siemens.com/content/00001123/default.aspx
• From the Siemens branch office near you www.buildingtechnologies.siemens.com or
from your system supplier
• From the support team at headquarters [e-mail] if
there is no local point of contact
Siemens assumes no liability to the extent allowed under the law for any losses
resulting from a failure to comply with the aforementioned points or for the improper
compliance of the same.
Note
Copyright notice
Quality assurance notice
Document use /
request to the reader