Installation Instructions

Document No. 129-801
Installation Instructions
June 19, 2015
Page 4 of 7 Siemens Industry, Inc.
Actuator/Valve Stem Connection, Continued
2. Crank down until you hear the stem connector
snap into place. See Figure 10.
Figure 10.
3. Return the crank arm to its storage location.
CAUTION:
Do not rotate the actuator on the valve once the
actuator and valve stem are connected, and/or
the anti-rotation device is connected to the valve
stem. Doing so will inadvertently adjust the flow
setting of the valve.
DIP Switches
Factory setting
1) Tolerance: + 1 second
2) Factory setting
LED Status
Wiring Diagrams
0 to 10V/4 to 20 mA
G System Potential
G0 System Neutral
G1 Y = 0 Vdc/4 mA: Actuator fully extended
(increasing control signal retracts actuator
stem)
G2 Y = 0 Vdc/4 mA: Actuator fully retracted,
(increasing control signal extends actuator
stem)
Yu/Yi Control Signal 0 to 10V/4 to 20 mA
U Position Indication
3-position
G System Potential
G0 System Neutral
G1 Control signal: Actuator stem extends
G2 Control signal: Actuator stem retracts
The installation is now complete.