Data Sheet for Product

SSA/P Series Electronic Valve Actuator Technical Instructions
24 Vac Floating or 0 to 10 Vdc Control Document Number 155-710
January 12, 2018
Information in this publication is based on current specifications. The company reserves the right to make changes in specifications and models as
design improvements are introduced. Product or company names mentioned herein may be the trademarks of their respective owners. ©2018 Siemens
Industry, Inc.
Siemens Industry, Inc.
Building Technologies Division
1000 Deerfield Parkway
Buffalo Grove, IL 60089
+ 1 847-215-1000
Your feedback is important to us. If you have
comments about this document, please send them to
[e-mail]
Document No. 155-710
Printed in the U.S.A.
Page 7
Troubleshooting
See Wiring for proper connections.
If the actuator does not provide full flow or full close off, check that the actuator is
properly attached to the valve. If not, turn power off, tighten the bonnet ring on to the
valve completely, and power up to recalibrate.
If the actuator becomes inoperative, replace it.
Disposal
The device is considered electrical and electronic equipment for
disposal in terms of the applicable European Directive and may not be
disposed of as domestic garbage.
• Dispose of the device through channels provided for this
purpose.
• Comply with all local and currently applicable laws and
regulations.
Dimensions
Inches (Millimeters)
Figure 11. Dimensions of the SSA/P Series Actuator in Inches (mm).
Service envelope
Minimum access space recommended:
8-inches (200 mm) above the actuator and beside the terminal plug.