User Manual

145 / 146
Siemens Desigo Insight, Operating the management station, V6.0 SP3 CM110588en01_11
Building Technologies Alarm handling 2018-09-05
It is often useful to check if a new alarm route works, without actually triggering an
alarm. This is the purpose of the “User message”.
1. Open the Alarm Router in the Desigo Insight taskbar.
2. Select File > Send user message….
3. Select the receiver type and name.
4. Select Message.
5. Enter a message in the text field.
6. Click Send. A user message is sent.
The test message should be received at the receiver. If not, check the Log Viewer
for specific errors.
If alarm tasks cannot be routed to receivers, they remain in the queue until either
sent or manually deleted.
1. Click in the Desigo Insight taskbar to start the Alarm Router.
2. Select View > Open Tasks .
3. Right-click the table Open Tasks.
4. Select one of the following:
Delete all tasks
Delete selected tasks
Delete all tasks for selected receiver
Hide all tasks for selected receiver
Delete filter
Test routing of alarm
messages
Delete queued tasks