System Manual
Table Of Contents
- SIMATIC RTLS Hardware
- Legal information - Warning notice system
- Table of contents
- 1 Introduction
- 2 Safety notices
- 3 System overview
- 4 Planning an RTLS system
- 5 Anchors
- 5.1 SIMATIC RTLS4030A
- 5.2 SIMATIC RTLS4330A
- 5.3 SIMATIC RTLS4420A
- 5.4 SIMATIC RTLS4430A
- 6 Gateways
- 6.1 SIMATIC RTLS4030G
- 6.2 SIMATIC RTLS4330G
- 6.3 SIMATIC RTLS4420G
- 6.4 SIMATIC RTLS4430G
- 7 Transponder
- 7.1 SIMATIC RTLS4030T
- 7.2 SIMATIC RTLS4060T
- 7.3 SIMATIC RTLS4083T
- 7.4 SIMATIC RTLS4084T
- 7.5 SIMATIC RTLS4460T
- 7.6 SIMATIC RTLS PCB OEM AC
- 7.7 SIMATIC RTLS PCB OEM AX
- 7.8 SIMATIC RTLS PCB OEM CHIRP
- 7.9 SIMATIC RTLS PCB OEM PULSE
7.5.1.5 Dimension drawing
6,0$7,&57/67
%86
581
5$',2
[
$17
Figure 7-5 Dimension drawing SIMATIC RTLS4460T - All dimensions specified in millimeters
7.5.2 Installation & Operation
7.5.2.1 Notes on installation
Before you install the devices, read this section carefully to ensure trouble-free installation and
operation.
The devices can only be used in conjunction with the RTLS localization system. Setup,
installation and use of the tools and clients of the RTLS localization system are described in the
corresponding manuals.
The device is intended for installation in a vehicle. Installation is to be performed by qualified
and trained personnel according to the operating instructions. In addition, installation must take
place in accordance with the respective instructions for the installation of electrical systems and
utilities.
Note the specifications in the section "Technical specifications" during installation and
operation. Protect the device against moisture.
Make sure that the ambient temperature does not exceed 70 °C and that the device is not
installed at a location where it is exposed to direct sunlight.
Transponder
7.5 SIMATIC RTLS4460T
162 System Manual, 04/2019, C79000-G8976-C577-01