System Manual
Table Of Contents
- SIMATIC RTLS Hardware
- Legal information - Warning notice system
- Table of contents
- 1 Introduction
- 2 Safety notices
- 3 System overview
- 4 Planning an RTLS system
- 5 Anchors
- 5.1 SIMATIC RTLS4030A
- 5.2 SIMATIC RTLS4330A
- 5.3 SIMATIC RTLS4420A
- 5.4 SIMATIC RTLS4430A
- 6 Gateways
- 6.1 SIMATIC RTLS4030G
- 6.2 SIMATIC RTLS4330G
- 6.3 SIMATIC RTLS4420G
- 6.4 SIMATIC RTLS4430G
- 7 Transponder
- 7.1 SIMATIC RTLS4030T
- 7.2 SIMATIC RTLS4060T
- 7.3 SIMATIC RTLS4083T
- 7.4 SIMATIC RTLS4084T
- 7.5 SIMATIC RTLS4460T
- 7.6 SIMATIC RTLS PCB OEM AC
- 7.7 SIMATIC RTLS PCB OEM AX
- 7.8 SIMATIC RTLS PCB OEM CHIRP
- 7.9 SIMATIC RTLS PCB OEM PULSE
Installation with support - Corner installation
Follow the steps below to mount the device to a corner:
1. Use the corner support as template and draw the bore holes on the corner.
2. Drill the holes with a suitable device.
3. Insert the matching anchors in the holes. (Anchors are not supplied with the device.)
4. Mount the corner support to the corner.
5. Mount the device to the corner support using the screws (M4). (Screws are not supplied with
the device.)
Installation with support - Mast mounting
Follow the steps below to mount the device to a mast:
1. Use the mast mount as template and draw the bore holes on the mast.
2. Drill the holes with a suitable device.
3. Insert the matching anchors in the holes. (Anchors are not supplied with the device.)
4. Install the mast mount to the mast.
5. Install the device to the mast mount using the screws (M4). (Screws are not supplied with
the device.)
Note
If drilling is not possible, you can also fasten the mast mount to the mast with cable ties, for
example.
6.2.2.3 Ethernet
When installing and connecting the Ethernet connection, observe the applicable general
conditions and their legal basis.
The Ethernet connection is connected to the Ethernet socket of the device. The cable must be
connected to the RJ45 plug before connection to the socket.
For the supply voltage of the device over PoE, a corresponding infrastructure such as PoE
injector or PoE switch is required.
6.2.2.4 Cleaning and maintenance
The device may only be opened by suitably trained and qualified personnel. Only authorized
dealers are permitted to repair the device.
Unauthorized opening of and improper repairs to the device may cause substantial risks to the
user. As soon as the device was opened without permission, warranty and liability of the
Siemens AG are rendered null and void.
Do not clean the enclosure with abrasive, alkaline or aggressive cleaning products or aids.
Gateways
6.2 SIMATIC RTLS4330G
92 System Manual, 04/2019, C79000-G8976-C577-01