User Manual

ManualsBrandsSiemens ManualsBurner EquipmentPhotoresistive Flame Detectors QRB1, QRB3

CC1N7714en

23.11.2017

Building Technologies Division

714

QRB1...A with large QRB1...A with small QRB1...B QRB3... with

flange and clamp flange and clamp with plug flange and clamp

Photo Resistive Flame

Detectors

QRB1...

QRB3...

Photo resistive detectors for use with Siemens burner controls, for the

supervision of oil flames in the visible light spectrum.

The QRB… are used primarily in connection with oil burner controls in

intermittent operation.

The QRB... and this Data Sheet are intended for use by OEMs which integrate the

flame detectors in their products.

Use

The QRB... are designed for the supervision of yellow-burning oil flames in connection

with burner controls type LAL..., LME7…, LMO..., LMV… and LOA…

They are suited for frontal or lateral (90°) illumination.

The maximum spectral sensitivity of the QRB… is about 600 nm, thus giving full

consideration to the maximum level of visible light radiation of yellow-burning oil flames.

Since the QRB… also acquires certain parts of the radiation spectrum of other light

sources (boiler room lighting, solar radiation, etc.), the standard regulations regarding

safety in connection with extraneous light still apply.

Summary of content (9 pages)

PAGE 1
7 QRB1...A with large flange and clamp QRB1...A with small flange and clamp QRB1...B with plug Photo Resistive Flame Detectors 714 QRB3... with flange and clamp QRB1... QRB3... Photo resistive detectors for use with Siemens burner controls, for the supervision of oil flames in the visible light spectrum. The QRB… are used primarily in connection with oil burner controls in intermittent operation. The QRB...
PAGE 2
Warning notes To avoid injury to persons, damage to property or the environment, the following warning notes must be observed! Do not open, interfere with or modify the flame detector!      All activities (mounting, installation and service work, etc.) must be performed by qualified staff Before making any wiring changes in the connection area, completely isolate the plant from mains supply (all-polar disconnection).
PAGE 3
Standards and certificates Note! Only in connection with burner controls! EAC Conformity mark (Eurasian Conformity mark) ISO 9001:2015 ISO 14001:2015 OHSAS 18001:2007 China RoHS Hazardous substances table: http://www.siemens.com/download?A6V10883536 Service notes When cleaning the detector, never use burner cleansing spray. Always use a clean and dry cloth exclusive. Mechanical design General Compact photo resistive flame detector with infused 2-wire thermoplastic cable.
PAGE 4
Type summary QRB1… ¹) These types of flame detectors are not available for order in all countries! Plug 40 --- --- --- --- 50 33 40 ● --- --- --- 50 35 40 --- --- --- --- 50 35 40 --- --- --- --- 50 48 70 ● --- --- --- 50 50 40 --- --- --- --- 50 50 40 --- --- --- --- 50 50 70 --- --- --- --- 50 50 70 --- --- --- --- 50 50 70 --- --- --- --- 50 68 70 ● --- --- --- 50 70 70 --- --- --- --- 50 70 70 --- --- --- --- 50
PAGE 5
--- --- 50 50 70 --- --- --- 50 50 70 --- --- --- 50 50 70 --- --- --- 50 68 70 ● --- --- 50 70 70 --- --- --- 50 70 70 --- --- --- 50 70 70 --- --- --- 50 148 70 --- 65 17 25 ● ● --- 65 35 40 --- 65 36 --- 105 --- --- QRB1C-A050B40A --- --- BPZ:QRB1C-A050B40H QRB1C-A050B40H --- --- BPZ:QRB1C-B030A25A QRB1C-B030A25A --- --- BPZ:QRB1C-B080B70A QRB1C-B080B70A --- --- --- BPZ:QRB1B-A050B70A1 QRB1B-A050B70A1 --- BPZ:QRB1B-A050B70A
PAGE 6
Type summary (cont'd) Accessories QRB1… (version without plug) Item Small flange, 21 mm spacing Part number ¹) 4 241 1462 0 Large flange, 36 mm spacing 4 241 1600 0 Clamp 4 186 1096 0 ¹) To be specified when ordering individual items QRB3 (green) Article no.
PAGE 7
Technical data General detector data Degree of protection Safety class Mounting position Detector cable - QRB1 - QRB3 Environmental conditions IP40 II Optional Cable included in scope of delivery! Stranded copper wire 2 x 0.75 mm² Jacket 5.2 mm dia., PVC Cable length according to «Type summary» Cable to be supplied by thirds. Recommended: H05VV-F 2 x 0.75 Application standards should be observed. Weight QRB1... (depending on type) QRB3... (without cable) Approx. 20...35 g Approx.
PAGE 8
Dimensions Dimensions in mm QRB1... Large flange Clamp Mounting hole 4 241 1462 0 4 241 1600 0 4 186 1096 0 at burner chassis 3,6 Small flange 26 QRB1...A without plug g 7714m07/0413 QRB1...B with plug 7 20 7714m08/0413 QRB1... with connector AGK53.0 7714m10/0413 QRB1x-xxxxxxxH with clamp 35 g 7714m11/0413 8/9 Building Technologies Division CC1N7714en 23.11.
PAGE 9
Dimension (cont'd) Dimensions in mm QRB3... QRB3 4 186 8806 0 4,6 4 286 1490 0  2017 Siemens AG Building Technologies Division, Berliner Ring 23, D-76437 Rastatt Subject to change! Building Technologies Division 9/9 CC1N7714en 23.11.