- Router User's Guide

Residential Gateway Family User Guide
5
Chapter 2
Physical Installation
This chapter covers the physical installation of the SpeedStream Router.
Minimum System Requirements
• DSL service and an Internet access account from an Internet Service Provider (ISP).
• Network cables for the device you intend to connect to the Router. Use standard CAT5 Ethernet
cables with RJ45 connectors.
• TCP/IP network protocol must be installed on all computers.
• For USB connection to the Router, the following operating systems are supported (if your Router
model supports USB):
− Windows 98, 98SE
− Windows 2000
− Windows ME or XP
− Mac OS versions 8.6 through 10.2.4
Note:
Your configuration may vary slightly from the instructions and illustrations in this chapter. Refer to
your service provider’s documentation, or contact them with questions regarding your specific
configuration.
Hardware Installation
You may position the SpeedStream Router at any convenient location in your office or home. No special
wiring or cooling requirements are needed; however, you should comply with the safety guidelines
specified in the
General Safety Guidelines section.
Basic Installation Procedure
1. Install line filters if necessary.
2.
Connect the cables.
3.
Install USB drivers if necessary.
4.
Configure network settings on your computer.
5.
Configure the Router via the Web-based management interface.
6. Reboot the computer if prompted. Whenever you are required to reboot the Router, allow five
seconds between turning off the unit and powering it back on.
2