Installation Instructions

Installation Instructions
Document No. 540-199
February 9, 2015
Autozero Module
Information in this publication is based on current specifications. The company reserves the right to make changes in specifications and
models as design improvements are introduced. Product or company names mentioned herein may be the trademarks of their respective
owners. © 2015 Siemens Industry, Inc.
Siemens Industry, Inc.
Building Technologies Division
1000 Deerfield Parkway
Buffalo Grove, IL 60089-4513
USA.
[phone]
Your feedback is important to us. If you have
comments about this document, please send them
to: [e-mail]
Document No. 540-199
Printed in the USA
Page 1 of 1
Figure 1.
Product Description
These instructions explain how to field install and/or
replace an Autozero module.
Product Numbers
540-380 Autozero Module
Expected Installation Times
4 minutes
Required Tools and Materials
Cordless drill/driver set (1/4 hex)
Item Number: 540-199, Rev. EA
Installation
1. Using Autozero module as a template, mark the
mounting location for the screws. (Screws do not
require starter holes.)
2. Install the screws in the marked location. Leave
screws protruding 5/32-inch.
3. Place Autozero module over screws and slide
into position.
4. Tighten screws until Autozero module is secure.
5. Connect air tubes and terminate wires. See the
appropriate controller instructions for wiring and
piping information.
NOTE: The AZM is not orientation sensitive.
Figure 1. Air Tube Connections.
The installation is now complete.