Installation Instructions

ManualsBrandsSiemens ManualsBuilding automationBACnet Protocol Implementation Conformance (PIC) Statement

Document No. 550-123

January 1, 2011

Siemens Industry, Inc. Page 3 of 6

NOTE: As a standard grounding procedure, ensure

that 3" - 5" ground wire is connected directly

on the common terminal on the secondary

side of the 24 Vac transformer.

8. Connect the tubing from the air velocity sensor

pickups to the ports on the controller. Connect

HI to HI and LO to LO.

Smoke Control Compliance

The following instructions and information apply if

used for smoke control sequence.

1. Install Smoke Control Listed products, enclosure

and transformer (see the Product Numbers and

Accessories sections for more information.

2. Input Rating:

24V 60 HZ 60VA maximum

3. Digital Output (DO) are the only I/O suitable for

smoke control application.

Digital Output (DO) Electrical Ratings:

5VA per DO/ maximum 40 VA total.

4. The room temperature sensor (RTS) is installed

in the same room as the TEC.

5. Connection from the TEC to the field panel is a

maximum 4000 feet, 24 AWG minimum.

6. Wiring Range:

Transformer: primary 14 AWG

24 Vac Input Power: 14 to 18 AWG

DO: AI: 18 to 20 AWG

DI: 18 AWG

LAN: 20 to 24 AWG

RST: 24 AWG

All circuits are power limited; FLN is RS-485, RTS is

RS-232. Digital Inputs (DI) are dry contacts.

See the following documents for more information

on configuring smoke control applications:

Smoke Control Systems Application and

Engineering Manual (125-1806)

Smoke Control System Application Guide

(125-1816)

NFPA and UL Standards Relevant to Smoke

Control System Application Guide (125-

1817)

NOTE: The 24 Vac relay module is not applicable

for smoke control application.

The installation is now complete.

Wiring Diagram

The controller’s DOs control 24 Vac loads only. The maximum rating is 5 VA for each DO. An

external interposing relay is required for any of the following:

• VA requirements higher than the maximum

• 110 or 220 Vac requirements

• DC power requirements

• Separate transformers used to power the load.

(for example part number 540-147, Terminal Equipment Controller Relay Module)