Installation Instructions

ManualsBrandsSiemens ManualsBuilding automationBACnet Protocol Implementation Conformance (PIC) Statement

Document No. 550-109

December 21, 2010

BACnet PTEC Dual Duct Controller

Siemens Industry, Inc. Page 1 of 4

Smoke Control Listed BACnet PTEC Unit Vent Controller.

Control Applications

6565 through 6569

Product Description

These instructions explain how to field install or

replace a Siemens BACnet PTEC Dual Duct

Controller.

Warning/Caution Notations

WARNING:

Personal injury/loss of life may

occur if you do not follow the

procedures as specified.

CAUTION:

Equipment damage or loss of

data may occur if you do not

follow the procedures as

specified.

Product Number

Siemens BACnet PTEC Dual Duct

Controller

550-497P

Shipping cartons includes a controller assembly

(controller board and cover), a mounting rail, and

two self-tapping/drilling screws.

CAUTION

Keep the unit in its static-proof bag

until installation.

Otherwise you run the risk of damage

to the PCA from electrostatic

discharge.

Summary of content (4 pages)

PAGE 1
Installation Instructions Document No. 550-109 December 21, 2010 BACnet PTEC Dual Duct Controller Smoke Control Listed BACnet PTEC Unit Vent Controller. Control Applications 6565 through 6569 Siemens BACnet PTEC Dual Duct Product Description These instructions explain how to field install or replace a Siemens BACnet PTEC Dual Duct Controller. Warning/Caution Notations WARNING: CAUTION: Siemens Industry, Inc.
PAGE 2
Document No. 550-109 Installation Instructions December 21, 2010 Accessories Low cost temporary temperature Installation QAM1030.008P50 sensor that enables space control if the permanent room or duct sensor is NOTE: All wiring must conform to national and local codes and regulations (NEC, CE, etc.). 1. Secure the mounting rail in the controller’s desired location. 2. Place the ESD wrist strap on your wrist and attach it to a good earth ground. 3.
PAGE 3
Document No. 550-109 Installation Instructions December 21, 2010 Wiring Diagrams CAUTION The controller’s DOs control 24 Vac loads only. The maximum rating is 12 VA for each DO. An external interposing relay is required for any of the following: VA requirements higher than the maximum 110 or 220 Vac requirements DC power requirements Separate transformers used to power the load. (for example part number 540-147, Terminal Equipment Controller Relay Module) Siemens Industry, Inc.
PAGE 4
Document No. 550-109 Installation Instructions December 21, 2010 Applications 6565, 6566, 6567, and 6568 with Hot Water Reheat. Application 6569 – Variable Air Volume with Changeover with Hot Water Reheat. Information in this publication is based on current specifications. The company reserves the right to make changes in specifications and models as design improvements are introduced. Other product or company names mentioned herein may be the trademarks of their respective owners.