Installation Instructions

ManualsBrandsSiemens ManualsBuilding automationBACnet Protocol Implementation Conformance (PIC) Statement

Table Of Contents

Document No. 550-128

January 1, 2011

Smoke Control BACnet PTEC Dual

Duct Controller

Item Number 550-128(AA) Page 1 of 6

Siemens BACnet PTEC Dual Duct Controller

Control Applications

6565 through 6569

Product Description

These instructions explain how to field install or

replace a Siemens BACnet PTEC Dual Duct

Controller

Product Numbers

Smoke Control Listed Siemens BACnet

PTEC Dual Duct Controller

550-497PK

Shipping cartons includes a controller assembly

(controller board and cover), a mounting rail, and

two self-tapping/drilling screws.

Warning/Caution Notations

WARNING:

Personal injury/loss of life may

occur if you do not follow the

procedures as specified.

CAUTION:

Equipment damage, or loss of

data may occur if you do not

follow the procedures as

specified.

CAUTION

Keep the unit in its static-proof bag until

installation. Otherwise you run the risk of

damage to the PCA from electrostatic

discharge.

Summary of content (6 pages)

PAGE 1
Installation Instructions Document No. 550-128 January 1, 2011 Smoke Control BACnet PTEC Dual Duct Controller Siemens BACnet PTEC Dual Duct Controller. Control Applications Warning/Caution Notations 6565 through 6569 WARNING: Product Description CAUTION: These instructions explain how to field install or replace a Siemens BACnet PTEC Dual Duct Controller.
PAGE 2
Document No. 550-128 Installation Instructions January 1, 2011 Expected Installation Time Accessories Low cost temporary temperature sensor that enables space control if the permanent room or duct sensor is not installed. QAM1030.
PAGE 3
Document No. 550-128 Installation Instructions January 1, 2011 3. Remove the controller from the static proof bag and snap it into place on the mounting rail. 4. Connect the FLN. 5. Connect the point wiring (see Wiring Diagrams). 6. Plug the room temperature sensor cable into the RTS port. 7. Connect the power trunk. DO NOT apply power to the controller without first consulting the specialist. Smoke Control Compliance The following instructions and information apply if used for smoke control sequence.
PAGE 4
Document No. 550-128 Installation Instructions January 1, 2011 • Smoke Control Systems Application and Engineering Manual (125-1806) NOTE: The 24 Vac relay module is not applicable for smoke control application. • Smoke Control System Application Guide (125-1816) The installation is now complete. • NFPA and UL Standards Relevant to Smoke Control System Application Guide (1251817) Wiring Diagram The controller’s DOs control 24 Vac loads only. The maximum rating is 5 VA for each DO.
PAGE 5
Document No. 550-128 Installation Instructions January 1, 2011 Applications 6565, 6566, 6567, and 6568 with Hot Water Reheat. Item Number 550-128(AA) Applications 6565, 6566, 6567, and 6568 with Electric Auxiliary Reheat.
PAGE 6
Document No. 550-128 Installation Instructions January 1, 2011 Application 6569 – Variable Air Volume with Changeover with Hot Water Reheat. Application 6569 – Variable Air Volume with Changeover with Electric Auxiliary Reheat. Information in this publication is based on current specifications. The company reserves the right to make changes in specifications and models as design improvements are introduced. Product or company names mentioned herein may be the trademarks of their respective owners.