Installation Instructions

ManualsBrandsSiemens ManualsBuilding automationBACnet Protocol Implementation Conformance (PIC) Statement

Document No. 550-151

October 26, 2016

Smoke Control BACnet PTEC Constant

Volume Controller

Generic Controller I/O Layout. See Wiring Diagram for application specific details.

Item No. 550-151 Rev. BA Page 1 of 7

Control Applications

6660, 6662, 6663

Product Description

These instructions explain how to field install or

replace a Siemens BACnet PTEC Constant Volume

Controller.

Product Numbers

Smoke Control Listed Siemens

BACnet PTEC Constant Volume

Controller

550-498PKA

Shipping cartons includes a controller assembly, a

mounting rail, and two self-tapping/drilling screws.

CAUTION

Keep the unit in its static-

proof bag until installation.

Otherwise you run the risk of

damage to the PCA from

electrostatic discharge.

ATTENTION

Ne pas retirer la carte de son

emballage avant son

installion.

Autrement, une décharge

électrostatique peut

endommager la carte

équipée.

Summary of content (7 pages)

PAGE 1
Installation Instructions Document No. 550-151 October 26, 2016 Smoke Control BACnet PTEC Constant Volume Controller Generic Controller I/O Layout. See Wiring Diagram for application specific details. CAUTION Control Applications 6660, 6662, 6663 Keep the unit in its staticproof bag until installation. Product Description Otherwise you run the risk of damage to the PCA from electrostatic discharge.
PAGE 2
Document No. 550-151 Installation Instructions October 26, 2016 Warning/Caution Notation NOTE: For smoke control application, primary rating is only 120V/60 Hz. WARNING Personal injury/loss of life may occur if you do not follow the procedures as specified. CAUTION Equipment damage or loss of data may occur if you do not follow the procedures as specified.
PAGE 3
Document No. 550-151 Installation Instructions October 26, 2016 4. Connect the FLN. NOTE: If the controller is being installed on a box with 1 or more stages of electric heat, the 550-809 MOV with preterminated spade connectors must be installed across the manufacturersupplied airflow switch. MOVs can be installed at the time the controller is factory mounted; coordinate with the box manufacturer prior to order placement.
PAGE 4
Document No. 550-151 Installation Instructions October 26, 2016 ATTENTION 6. Wiring Range: Il est très important que le neutre qui alimente le TEC soit mis à la terre à la source de l’alimentation 24 Vca. Risque de fonctionnement incohérent de l’équipement ou de dégats si le neutre n’est pas mis à la terre. The installation is complete.
PAGE 5
Document No. 550-151 Installation Instructions October 26, 2016 NOTE: When wiring any actuator that uses a 0 to 10V control signal and ties AC neutral to DC common, an additional wire must connect the actuator AC neutral to the DC common of the PTEC/TEC AO being used to control the actuator. Wiring for AI with a 4 to 20 mA Sensor. CAUTION Each 4-20 mA sensor requires a SEPARATE dedicated power limited 24 VDC power supply. DO NOT use the same transformer to power both the sensor and the controller.
PAGE 6
Document No. 550-151 Installation Instructions October 26, 2016 Application 6660 – Constant Volume Cooling Only. Page 6 of 7 Application 6662 – Constant Volume with Electric Reheat. Siemens Industry, Inc.
PAGE 7
Document No. 550-151 Installation Instructions October 26, 2016 Cyber security disclaimer Products, solutions and services from Siemens include security functions to ensure the secure operation of building automation and control, fire safety, security management, and physical security systems. The security functions on these products, solutions and services are important components of a comprehensive security concept.