Installation Instructions

ManualsBrandsSiemens ManualsRoom controlsWireless Field Level Network (WFLN) Technical Specification Sheet

Document No. 563-200

January 29, 2010

WFLN Series

Wireless Field Panel Transceiver (FPX)

(Version 2)

Item Number 563-200, Rev. CA Page 1 of 4

Figure 1. Wireless Field Panel Transceiver.

Product Description

The Wireless Field Panel Transceiver (FPX) is

mounted at or near the field panel and is powered by

24 Vac. The antenna can be mounted either directly

to the radio or remotely, for installations where the

location of the FPX would cause the antenna to be

shielded—for example, when the FPX is mounted

inside a field panel enclosure.

Product Numbers

563-055 Wireless Field Panel Transceiver

(FPX) with WRTS Support

(Version 2.x)

563-007 Direct Mount Antenna

563-008 Remote Mount Antenna

Transceivers do not come with antennas.

Antennas must be ordered separately.

Accessories

563-027 Pre-terminated Cable Kit

Includes two 14 in. (36 cm) cables:

– Power

– Communication

Summary of content (4 pages)

PAGE 1
Installation Instructions Document No. 563-200 January 29, 2010 WFLN Series Wireless Field Panel Transceiver (FPX) (Version 2) Accessories 563-027 Pre-terminated Cable Kit Includes two 14 in. (36 cm) cables: – Power – Communication Related Products Wireless Field Level Network (WFLN) 563-054 Wireless Field Level Network Transceiver (FLNX) 563-056 Wireless Transceiver Tool (TLX) QAA2290.EWSC Wireless TEC Room Temperature Sensor (WRTS) – Sensing only QAA2290.
PAGE 2
Document No. 563-200 Installation Instructions January 29, 2010 Antenna Mounting Direct Mount Antenna The preferred mounting configuration is to mount the FPX outside the field panel enclosure in a location where it will establish the maximum number of communication links with Wireless Field Level Network Transceivers (FLNXs). For example, for a VAV application this will likely be above the field panel in the ceiling plenum (Figure 2). Figure 2. Radio Mounted Outside Field Panel Enclosure.
PAGE 3
Document No. 563-200 Installation Instructions January 29, 2010 Installation 1. Determine the optimal location of the FPX and antenna for RF communications. 2. Mount the FPX using the provided screws. You can also use double-sided tape or ® VELCRO fasteners. 3. Set the Channel and Network ID switches to the settings selected for the WFLN. 4. Connect the communication port of the field panel to the FPX. The maximum cable length is 4000 ft (1219 m). 5. Connect to 24 Vac power. 6.
PAGE 4
Document No. 563-200 Installation Instructions January 29, 2010 FCC Notes Industrie Canada Certification This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: This device has been designed to operate with an antenna having a maximum gain of 5dBi. An antenna having a higher gain is strictly prohibited per regulations of Industry Canada. The required antenna impedance is 50Ω. 1. This device may not cause harmful interference. 2.